Palmgren 9683122, Руководство по эксплуатации и список запасных частей

Страница: 7 / 24

7
Palmgren Operating Manual & Parts List 9683122 & 9683123
OPERATION (CONTINUED)
GRINDING BLADE
1. After annealing the blade, the metal buildup or flash must be
ground from the blade.
2. Toggle grinder switch to the ON position.
3. Flip the grinder guard open, exposing the top of the grinding
wheel.
4. Weld should be ground to same thickness as blade.
5. Grind flash off under-side of blade taking care not to grind into
blade.
6. Turn blade inside out and grind other side of blade same as first
side (or, flip the grinder guard to the closed position and use the
bottom of the wheel).
7. Take care not to grind into blade.
8. Turn blade inside out again (to original shape).
9. Turn grinder off when grinding is completed. The blade must be
annealed again.
ANNEAL BLADE AFTER GRINDING
1. After flash has been removed, anneal the blade a second time.
The weld may have been hardened by heat created during
grinding. Repeat “Blade Annealing” step.
2. After second blade annealing operation, the blade is ready for
installation onto band saw. Follow band saw instruction when in-
stalling and adjusting blade.
MAINTENANCE
Steps required to keep the saw in optimum operating condition
have been described under “Operating Instructions.” The Safety Pre-
cautions should be performed before operation.
For proper maintenance:
•
Keep saw clean and dry. Sweep off spots where chips have col-
lected.
•
Lubricate the unpainted surfaces with a light application of
medium consistency machine oil to prevent corrosion after
cleaning.
•
Replace dull blades and blades from which teeth have been
stripped. A clean saw with a sharp blade will yield the best cut.
•
Internal parts of the band saw have been completely lubricated
at the factory and do not need to be relubricated.
WARNING
: Make certain that the saw is disconnected from the
power source before attempting to service or remove any compo-
nent.