Pallmann GECKO FLEX, Перевод оригинального руководства

Страница: 13 / 16

13 09/2010
Press the spindle lock (1).
The sanding plate (2) can usually be removed
by hand. If it is tight, release it using
the face spanner provided.
Replace the sanding disc (2) for a new one.
Press the spindle lock (1) and screw
in the sanding disc (2) in a clockwise direction.
Tip: Tighten the sanding plate by hand so that it is easier to remove later on.
8.2 Replacing the abrasive
Caution!
Replace the abrasive in good time. A dull abrasive can lead to premature wear of the
grinding disc and overload the machine.
Caution! Risk of injury!
Only replace the sandpaper when the motor has come to a stop and the mains plug
has been pulled out.
Caution! Hot surface!
After extended use, the sandpaper will be very hot.
1. Pull the worn sandpaper off the velcro.
2. Attach new sandpaper. Pay attention to the hole pattern.
Sanding plate without velcro
1. Undo the clamping disc with a Torx spanner.
2. Replace the sandpaper and retighten the
clamping disc.
8.3 Replacing the brush
1. Break through the hole (3) with a screwdriver
and remove the brush.
2. Insert a brush in the slot.
Tip
BILD
2
1
3