Page
4
of
48
1. Introduction
All information presented in this document has been verified according to applicable standards and
guidelines at the time of writing. All legal and other binding regulations for personnel protection,
accident prevention and protection of the environment applicable in the country of use of the system
must be observed.
This instructions manual is intended to describe and explain the iCELLis 500+ bioreactor control
system functions in standard configuration and general operating conditions. It provides information
required for installation and operation of the system in these conditions. Read the manual carefully
before operating the iCELLis 500+ bioreactor control system.
The Instructions for Use (IFU) must be read, understood and applied by all personnel authorized to
operate, clean, service and maintain the system.
CAUTION!
The iCELLis 500+ control system must be used in accordance with instructions detailed in this manual.
Utilization must be carried out only by authorized persons trained to the iCELLis 500+ control system
operation.
Operation of the equipment may require other devices, instruments or safety equipment than the one
described in this Instruction for Use. This document does not include detail about such conditions and
related obligatory guidelines.
Warnings and safety messages are applicable only to iCELLis 500+ control system.
The figures, illustrations, parameters values and settings shown in this document are only examples
and should not be used for a given application. Exact settings are provided through configuration
documents or should be obtained empirically for a specific application.
This Instruction for Use has been released for the iCELLis 500+ control system hardware with the
iCELLis 500+ software version 1.03.
The iCELLis 500+ control system serial number can be found on the model plate located at the back
of the equipment. The iCELLis 500+ software version can be found in Software HEADER after
start-up of the controller.
