Page
16
of
48
5. Unpacking and Installing the iCELLis 500+ Control System
The required materials for unpacking and installing the iCELLis 500+ control system are detailed below:
•
Forklift with minimum fork length of 1.4 m capable of lifting 1.320 kg at the full length of
the forks.
•
Stepladder, scissors, spirit level, spanner (wrench):13 and 24 mm, adjustable spanner: jaw
capacity 25 - 26 mm, Metric hex keys: 4 mm, 5 mm and 6 mm, small flat screw driver
5.1 Unpacking
WARNING!
Risk of injury to personnel and/or damage to equipment!
The crated iCELLis 500+ control system should always be lifted in the upright position. Once outside
the crate, the hardware should only be lifted from the side. Before lifting, ensure that the lifting device
forks pass all the way under the box section of the hardware.
ALERT!
Risk of damage to equipment!
Before placing the iCELLis 500+ control system on the floor, be sure the floor can support the weight
of the system.
ALERT!
Risk of injury to personnel and/or damage to equipment!
Never lift the iCELLis 500+ control system by the top.
The iCELLis 500+ control system is shipped within 2 wooden crates with the following dimensions
and weight:
Table 3: Weight and dimensions of iCELLis 500+ control system crates
iCELLis 500+ Control System
Accessories and Documentation
Crate weight
~850 kg
~300 kg
Crate dimensions
(H x W x L)
2135 x 1120 x 1760 mm
1800 x 800 x 1200 mm
Inspect the crate to ensure it has not been damaged, also check the ‘TIP N TELL’ and Shock indicator
(if applicable) located on the side of the crate for signs that the crate has been tipped or mishandled.
It is recommended that two persons uncrate the iCELLis 500+ control system together. The four sides,
top and bottom sections of the crates are held together using the fixings shown in Figure 6b.
To uncrate: Remove one of the larger side panel then remove the top panel of the crate and finish with
the remaining vertical panels. Remove the first layer of plastic wrap, then the wooden support for the
top assembly and the second wrap (Figure 6 f-h). Proceed similarly with accessories and
documentations crate (Figure 6i).
Lift the iCELLis 500+ control system from the base of the box using a forklift at the lifting points on the
side of the unit (Figure 6h). Ensure the forks are positioned under the controller framework prior to
lifting. Lifting in any other way may cause damage to the hardware. Once the iCELLis 500+ control
system has been lifted move the crate base and place the iCELLis 500+ control system on the floor.
