Tap the RFID card against the RFID symbol on
the front of the charger to activate the charging
process.
STEP3 / Tap the RFID Card
STEP4 / Charging
•
When the charging cycle is completed, the blue
light (CHARGE) is constantly lit.
•
Release the charging connector from the vehicle
inlet, and replace its weatherproof cap*
•
Upon disconnection from the vehicle, the charger
will return to the standby mode (step 1), with the
green (READY) light constantly lit.
STEP5 / Charging Complete
The blue light (CHARGE) begins to flash automatically,
charging is in process.
•
If the red light (FAULT) is lit, remove the charge
connector from the vehicle and re-insert.
•
If red light is still lit, please refer to "7.5 Error and
Warning Messages".
* Fitting the weatherproof cap on the vehicle charge connector when not in use
will greatly assist in preventing the buildup of unwanted dirt and debris on the
charging contacts, therefore reducing the risk of poor electrical connection which
could result in premature failure of the device.
A S P E N Series - User Manual
23
