Palax COMBI M, Инструкция по эксплуатации

Страница: 13 / 31

Ohjekirja Palax combi M 2004.1 En
13
1 2 3 4
3
4
1
2
3
4
5
1 2 3 4 5 6 7
2.6 Protective cover of cross-cut saw-
blade, Figure 3
‰
Put the protective cover of saw-blade 1 in
place.
‰
Put the shaft pin in place.
‰
Do not wrench too tight. The casing must
be easy to move (17 mm spanner).
2.7 Protective net of cross-cut saw-blade,
Figure 3
‰
Put the cover net of saw-blade 2 in place
(19 mm spanner).
2.8 Protective cover of splitting trough,
Figure 4
‰
Put the protective cover 4 (Figure 3) in
place.
‰
Fix the limiting bolt 3 in accordance with
Figure 3.
‰
Fix the plastic cover extension 1 (Figure 4).
‰
Put the safety wedge 2 (Figure 4) in place.
‰
Fix the plastic rear cover 3 (Figure 4).
‰
Do not fix the conveyor belt cover 4 until
the assembly of the conveyor is completed.
2.9 Assembly of the log-stop, Figure 5
‰
Remove the cotter 6 from the end of shaft
2.
‰
Remove the log-stop (24 mm spanner).
‰
First push the shaft end through the lug 3,
place the log-stop on the shaft and push
the shaft through the lug 6 in the table end
and put the cotter in place.
‰
Attach the end of the spring 1 to the lower
edge of the support plate at the table.
2.10 Setting the log-stop
‰
Set the desired cutting length using the
scale, and wrench tight the screw of the log-stop.
‰
As you draw back the table, the limiter turns automatically to the limiting position.
‰
As you push the table in, the log-stop automatically turns away from the log, allowing it
to fall down freely.
2.11 Topping up hydraulic oil
‰
Hydraulic oil volume 40 litres.
‰
Oil type Univis 32, SHELL Tellus 32, NESTE HYDRAULI 32 or equivalent.
‰
Only use fresh, clean oil.
‰
Observe particular cleanliness during the oil change, because the smooth operation of
the machine is highly dependent on the purity of the oil.