Ohjekirja Palax combi M 2004.1 En
14
6
1
3
2
4
7
1
1
2
8
9
3
1
2
1
4
2.12 Assembly of the conveyor, Figure 6
At this stage the conveyor is on the ground.
Remove bolts 1 and 2 from the attachment fork
(19 mm spanner).
Push the attachment fork on the conveyor into the
corresponding fork on the machine.
Put the attachment bolts in place and tighten them
slightly, allowing the conveyor to still move in the
fork on the machine.
2.13 Installing the V-belt, Figure 6
Put the V-belt 4, type A 136 on the angular gear
and conveyor pulleys.
Put the belt onto pulley 1 as illustrated in Figure 7,
in order to prevent the sawdust from falling on the
belt.
Adjust the tightness of the belt close to the
suitable tightness with adjustment screw 3.
Tighten the attachment screw 1 of the conveyor early enough to prevent the tightening
of the belt from drawing the conveyor to an oblique position.
After that, tighten the belt to its final tension. The tension is ideal when the belt gives
way about maximum 5 cm under a 2 kg force in the middle.
Tighten the attachment screw – and the other one as well.
Put the V-belt cover in place.
Lift the conveyor into the upright position against
the transport support.
2.14 Installing the attachment plate and the
support wires, Figure 8
Lift the conveyor into the upright position against
the transport support.
Fix the plate to the lugs 2 at the conveyor.
The attachment plate has three holes for
attachment of the conveyor support wire.
Put the wires into the holes, as required.
If you are processing firewood onto a trailer with high sides, then fix the wires in the top
holes.
If you are processing firewood in, for example, a low transport cage, then fix the wires
in the lowest holes.
2.15 Installing the conveyor winch, Figure 9
optional
Fix the winch in the lugs 2 at the conveyor.
Fix the winch wire in the attachment bolt 3.
Fix the support wires in holes 1. The attachment
plate has three holes for attachment of the wire.
If you are processing firewood onto a trailer with
high sides, then fix the wires in the top holes.
If you are processing firewood in, for example, a
low transport cage, then fix the wires in the lowest
holes.
Содержание COMBI M
