062702
16 Theremax
( ) Push the lens of LED D16 through the hole provided for
it in the control panel as shown in fig 3. Connect the
free end of R77 to lug #3 of S1 as shown.
DO NOT SOLDER this connection yet.
( ) Prepare a 10" length of #22 stranded wired and connect
one end to lug #3 of S1. Solder the resistor lead and
wire to the lug. If you have difficulty pushing the wire
through the hole, you can crimp it around the lug
instead. The free end will connect in later steps.
( ) Connect the anode lead of LED D16 to lug #2 of S1.
DO NOT SOLDER this connection yet.
Theremax wiring continues by connecting the wires previously
soldered to the circuit board to the pots and jacks as detailed in
fig 4. Notice that previous wiring has been eliminated from this
drawing to give a better view of the present operations.
FROM
TO
( ) "A"
R79-2 (s1)
( ) "B"
R79-3 (s2)
( ) "C"
R80-3 (s2)
( ) "D"
R80-2 (s1)
( ) "E"
R81-3 (s1)
( ) "F"
R81-1 (s1)
( ) "SG"
J1-S (s3)
( ) "H"
R82-3 (s1)
FROM
TO
( ) "J"
R83-3 (s1)
( ) "K"
R84-3 (s1)
( ) "L"
J3-T (s2)
( ) "M"
J2-T (s2)
( ) "N"
J2-R (s1)
( ) "R"
J1-T (s1)
( ) "S"
J5-T (s2)
( ) "T"
J6-T (s1)
( ) "+"
S1-2 (s2)
THIS COMPLETES THE ELECTRONIC ASSEMBLY OF THE Theremax.
Before continuing with case assembly take a break then come back and check your work
completely. Pay particular attention to the quality of solder connections and orientation of
polarized parts.
CASE ASSEMBLY
General details of case assembly and electronic installation are shown in fig 5.
