Pacific Power Source UPC-32, Руководство по эксплуатации

Страница: 38 / 128

SECTION 4 OPERATION
28
4.1.1 OVERVIEW (continued)
The SETUP MODE is used to make changes in system configuration. Examples are:

Copy and Delete Programs

Copy, Edit, and Create Waveforms

Set Min. and Max. Voltage Limits

Set Min. and Max. Frequency Limits

Engage and Disengage CSC (Continuous Self Calibration)

Set the Metering Sense Point
– Internal or External

Set Slew rates

Set Transition Time

Set Transformer Ratio

Enable keyboard lockout

Set initial power on output voltage

Monitor UPC and Power Source status

View Firmware Version

Enable Calibration Mode for Metering

Adjust LCD View Angle and Backlight Intensity

Set GPIB Device Address or Serial Interface Parameters

Erase Memory

Set Amps-to-Volts Current Metering Ratio

Define Current Transformer Location

Set Output Range - for power sources that support it

Define the Number of Power Source Amplifiers

Synthesize Waveforms from Harmonic values (Option)

Enable, Set, and Calibrate Programmable output impedance (Option)

Enable Current Protection
SELECTING OPERATING MODES
On first turn-on, the system will operate using a set of default parameters stored in memory. The display will
be the V/I METER display. This is the default - and most frequently used - display. It shows all basic
operating parameters, and in the lower left portion shows the operating mode. All operating modes can be
accessed from the V/I METER display. If the V/I METER display is not active, pressing
CLEAR a few times
will always return to the V/I METER display.
MANUAL OPERATION ( 4.3 ) - is available by pressing Va, Vb, Vc or F for voltage or frequency adjustments.
An LED will light above each pressed key to indicate an active selection. The selected parameter
can then be changed by typing a new value and pressing
EXECUTE or holding one of the SLEW
keys (
︿
or
﹀
).
PROGRAM OPERATION ( 4.4 ) -requires pressing PROGRAM, selecting a program number (1-99) and
pressing ENTER to display the values stored in that program. Pressing EXECUTE will then cause
the UPC to use those values. If a transient has been stored in the active program, pressing TRANS
will activate the transient.
PROGRAM EDIT ( 4.5 )
– is accessed by pressing
PROGRAM, select a program number (1-99) and press
ENTER to display the stored program values. Press EDIT to allow changes to the values stored in
that program, ENTER to move the cursor through the screen, and STORE to save the values.
SETUP MODE ( 4.6 ) - Pressing the fn key presents the SETUP menu: copy or delete programs and
waveforms, erase memory, set meter sense points, toggle features on or off, set Programmable
Impedance (option), set range (if supported), transition time, frequency and voltage limits, LCD view
angle and backlight, perform metering calibration, view status for system information (e.g. firmware
version), GPIB device address or Serial interface parameters, transformer ratio, amps to volts ratio,
number of power amplifiers and current transformer location.