For technical questions, please call 1-800-444-3353;
Troubleshooting section at end of manual.
SKU 95672
PAGE 1
OPERATIOn
Make sure the Power Switch is in the “OFF” position.
Attach the High Pressure
Hose (2) to the Pressure Washer.
Attach the Adjustable Lance () or Turbo Lance (4) onto the Lance Gun (1), and
press and twist the Lance into the Gun until the Lance locks in place.
nOTE:
The Pressure Washer will not pressurize if the unit is not completely as-
sembled. It will not work properly with only part of the unit installed.
Connect a Garden Hose (not included) to the Inlet Port (0) of the Pressure Washer.
Make sure all connections are tight. Then, open the water supply valve
fully
. If
leaks occur, shut off water and retighten connections.
IMPORTAnT! Prior to turning on the Pressure Washer, connect the unit to the
water supply. Turn on the water, disengage the safety, and squeeze the Trigger
until water flows out of the Lance gun (31) without sputtering.
This removes
air from the system and allows the unit to properly perform.
Failure to follow this
step can damage the Pump.
Test the cleaning capabilities and the run before starting your cleaning project, as
explained on page 16, #1. Turn the Power Switch to the “ON” position.
The motor
will briefly run when the switch is first turned on to build up pressure
and
then go to standby until the trigger is squeezed.
DO nOT ALLOW THE UnIT TO
REMAIn IDLE FOR MORE THAn A MInUTE OR TWO; the unit will build up
heat when it is on standby mode.
Point the Nozzle in a safe direction. Then, disengage the Safety and squeeze the
Trigger. Switch the unit’s switch to the OFF position whenever the gun is not in use.
Clean the area, following the tips contained in the Operating Tips section.
When finished spraying, fully engage the Trigger Safety Lock, turn the Power Switch
to its “OFF” position, and turn off the water supply.
WARnIng: Do not disconnect the high-pressure hose or water inlet hose
until all pressure is discharged safely.
IMPORTAnT!
When turning off the unit after use, high pressure will remain inside
the unit’s High Pressure Hose (2), and the water inlet hose. Point the Lance Gun
(1) in a safe direction and hold the trigger down for several seconds. Then, release
the Trigger and remove the Lance (, 4). Hold the Trigger until water stops flowing
from the gun. The high-pressure hose and water inlet hose can be disconnected
after the pressure is released.
Store the pressure washer and all accessories in accord with the directions under
Storage
on page 17.
IF AnY UnEXPEcTED PROBLEMS ARISE, PLEASE REFER TO THE
TROUBLESHOOTIng SEcTIOn AT THE EnD OF THIS MAnUAL.
1.
2.
.
4.
5.
6.
7.
8.
9.
