Pacific hydrostar 65078, Руководство по установке и эксплуатации

Страница: 9 / 37

Page 9 For technical questions, please call 1-800-444-3353. SKU 65078
Screw the Wand (20) onto the Gun 5.
and secure with the grommet.
Choose the right Nozzle (5) for the
6.
job. Pull back the quick connect
collar and push the Nozzle onto the
end of the Wand. Make sure the
quick connect collar locks the Nozzle
in place.
Red Nozzle - direct spray stream. •
This Nozzle should only be used
on hard surfaces such as concrete
or metal. This Nozzle can damage
wood.
Yellow Nozzle - 15° spray range.
•
This Nozzle is used to clean small
areas.
Green Nozzle - 25° spray range.
•
This Nozzle can be used to clean
larger areas.
White Nozzle - 40° spray range.
•
This Nozzle can be used to clean
very large areas.
Black Nozzle - This Nozzle is used
•
with pressure washer detergent.
Hose
connection
water inlet
connection
detergent inlet
connection
Pressure
regulator
Knob
7. Connect the water supply to the
Water Inlet Connection. The water
source must be able to provide a
minimum of five gallons of clean, cold
water per minute at 20 PSI. Only
use a hose that is rated to meet this
capacity.
if using detergent:
Read detergent directions. Connect 8.
one end of the Detergent Inlet Hose
(8) to the Detergent Inlet Connection,
and the other end into the container
holding the detergent. Only use
detergents specified for use with
Pressure Washers. The Pressure
Washer will draw one gallon of
detergent for every seven gallons
of water. Only use the Black (low
pressure) Nozzle when spraying
detergents.