Pacific hydrostar 65078, Руководство по установке и эксплуатации

Страница: 8 / 37

Page 8 For technical questions, please call 1-800-444-3353. SKU 65078
rev 09c
Basic sPeciFicatiOns
Fuel
Type
86+ octane unleaded
gasoline
Capacity 0.95 Gallons
Engine Oil
Type SAE 10W30 above 32° F
5W30 at 32° F or below
Capacity 0.63 Quarts
Pump Oil
150ml (5 Oz.) SAE
10W-30 Non-detergent
Engine Speed 3,600 RPM
Engine Family 7CGPS.1961 GA : EM
Water Flow 3 GPM Maximum
Maximum Pressure 2,800 PSI
note: Additional specifications found
in the TECHNICAL ENGINE
SPECIFICATIONS chart in this
manual.
The emission control system for
this Generator’s Engine is warranted for
standards set by the U.S. Environmental
Protection Agency. For warranty
information, refer to the last pages of this
manual.
At high altitudes, the engine’s
carburetor, governor (if so equipped), and
any other parts that control the fuel-air
ratio will need to be adjusted by a qualified
mechanic to allow efficient high-altitude
use and to prevent damage to the engine
and any other devices used with this
product.
unPacKing
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon
as possible.
set uP instructiOns
read the entire iMPOrtant
saFetY inFOrMatiOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
risk of accidental
starting; resulting
in serious personal injury.
turn the Power switch of the
equipment to its “OFF”
position, wait for the engine to
cool, and unplug the spark
plug wire(s) before
assembling or making any
adjustments to the equipment.
note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
assembly
This equipment has a spark 1.
arresting muffler included. A spark
arresting muffler is required by law
in California, on some US Forest
Service land, and possibly in other
areas or situations.
Attach the Handle (14) onto the
2.
Frame (17) with the Handle Bolts (15)
and Nuts (16).
Attach the Hose (18) to the Hose
3.
Connection on the unit. (See picture
on the next page.)
Pull the Collar at the end of the hose
4.
back and attach the Gun (19) to the
hose.
warning