Pacific hydrostar 65078, Руководство по установке и эксплуатации

Страница: 15 / 37

Page 15 For technical questions, please call 1-800-444-3353. SKU 65078
area away from bystanders, use
pressurized air to blow dust out of
the air filter.
If this does not get the filter
reasonably clean, replace it.
For foam filter elements: b.
Wash the element in warm water
and mild detergent several times.
Rinse. Squeeze out excess water
and allow it to dry completely. Soak
the filter in lightweight oil briefly, then
squeeze out the excess oil.
Install the new filter or the cleaned 4.
filter. Secure the Air Cleaner Cover
before use.
spark Plug Maintenance
Disconnect spark plug wire from 1.
end of plug. Clean out debris from
around spark plug.
Using a spark plug wrench, remove
2.
the spark plug.
Inspect the spark plug:
3.
If the electrode is oily, clean it using a
clean, dry rag.
If the electrode has deposits on it,
polish it using emery paper.
If the white insulator is cracked or
chipped, the spark plug needs to be
replaced.
When installing a new spark
4.
plug, adjust the plug’s gap to the
specification on the Technical
specification chart. Do not pry
against the electrode, the spark plug
can be damaged.
Install the new spark plug or the
5.
cleaned spark plug into the engine.
Gasket-style: Finger-tighten until the
gasket contacts the cylinder head,
then about 1/2-2/3 turn more.
Non-gasket-style: Finger-tighten until
the plug contacts the head, then
about 1/16 turn more.
Apply dielectric spark plug boot
6.
protector (not included) to the end of
the spark plug and reattach the wire
securely.
Fuel Filter replacement (if equipped)
warning! risK OF Fire
Or exPLOsiOn. Replace the
fuel filter in a well-ventilated
area away from ignition
sources. Do not smoke.
Wait for engine to cool completely 1.
before proceeding.
Wear protective gear including, ANSI-
2.
approved safety goggles, NIOSH-
approved dust mask/respirator, and
nitrile gloves.
Close fuel valve leading from gas
3.
tank completely.
Take note of the fuel filter’s 4.
orientation.
Place a suitable container under the
5.
fuel filter.
Disconnect the fuel lines leading to 6.
and from the fuel filter and allow fuel
to drain onto the container.
Install new fuel filter in the same 7.
orientation. Make sure to properly
secure both fuel lines.
Clean up and properly dispose of all
8.
fuel.
Wait for at least one hour before use
9.
to allow all residual fuel vapors to
dissipate. to prevent Fire, do not
start the engine while the smell of