Pacific Floorcare S-SERIES, Инструкция по эксплуатации и каталог запасных частей

Страница: 12 / 76

12
Connect the cleaning pad to the disk pad drivers by centering them on the drivers.
MACHINE PREPARATION
ATTACHING CLEANING PADS TO YOUR PAD DRIVERS - DISK HEAD
Depress position “A” for 1 second
then depress position “B”
1
If using floor pads with your pad drivers:
1
2
3
Place your pad drivers on a work surface and remove the center lock fitting from the pad drivers. To do so, squeeze the center lock wires
inward and lift the center lock off the pads.
Remove the pad drivers by locating the automatic off switch on the lower control panel at the rear of the machine. Depress position “A”
for 1 second and then depress position “B” to “click-off” the pad drivers.
4
Squeeze center lock wires inward and press center lock down, tab side first, compressing the pad and then release the wires so that they
lock in place holding the pad. Repeat for the other pad driver.
NOTE:
The S-Series pad drivers are tufted pad drivers. Do not use a pad driver on the floor without a pad in place. This will cause damage
to your floor.
Disconnect center lock fitting & lay
next to the pad driver
Center pad on pad driver
Squeeze center lock wires inward,
press down onto pad & release wires
2
3
4
Close up showing center lock tab &
wires
4
wires
tab