Pacific Floorcare S-SERIES, Инструкция по эксплуатации и каталог запасных частей

Страница: 14 / 76

14
ATTACHING A PAD TO YOUR ORBITAL PAD DRIVER
The orbital unit can be used for daily cleaning; however it specializes in chemical-free finish removal for low-cost finish maintenance
programs. The following directions show how to prepare the machine for both applications.
For cleaning, the orbital unit is fit with a rectangular, 28 in (711 mm) x 14 in (356 mm) pad. The head comes standard with a rectangular pad
drive plate with a Mighty-Lok® connection system.
MACHINE PREPARATION
ATTACHING YOUR PAD - ORBITAL HEAD
Red backer pad & Velcro pad
retainer (black) alignment
shown above with surface prep
pad (brown) pulled away
Align the front corners of the pad
and press to adhere
Proper alignment of pad
Lower the scrub head using the
foot pedal
For chemical-free finish removal, it requires the addition of a specialized surface
preparation pad. The application still requires the attachment of a traditional
cleaning pad first. This pad acts as a “backer pad” which compensates for low
and high spots in the floor.
Proper alignment of pad
To attach the pad, align the front corners of the pad to the front corners of the orbital drive plate and press to attach.
Use the foot pedal to lower the scrub deck down onto the pad ensuring alignment from front-to-back and side-to-side.
When the head is properly set onto the pad, you are ready for cleaning.
1
2
3
1 2
3
4 5
Align the Velcro pad retainer along one length of the red, backer pad and press
down. This will leave a 2” gap along one side of the backer pad. Then place
the surface prep pad on top of the pad retainer, centering it from front-to-back
& side-to-side with the red pad. The 2” gap left by the pad retainer needs to be
at the front of the machine so that water can fully saturate the pad. Align your
pad assembly with all corners of the pad driver and press upward. The red
backer pad should be in closest contact with the pad driver.
Finish the operation by using the foot pedal to lower the scrub deck down onto
the surface preparation pad, once again ensuring alignment from front-to-back
and side-to-side. When the head is properly set onto the pad, you are ready
for your finish maintenance program.
4
5