Pacific energy Estate A Series, Инструкция по установке и эксплуатации

Страница: 18 / 36

18
BURNER INSTALLATION
The glass frame and window trim overlay must be removed to install
the burner into the firebox. The glass frame is held in place by two
over-center latches located under the firebox.
1)
Fold down the front bottom louver, if installed, to access the
screw retaining the window trim overlay. Remove the screw and
swing the bottom out to clear. Lift to disengage from the top and
remove. Place on a smooth surface to avoid scratching.
2) Disengage the over-center latches by pulling each lever down
and forward. Grasp the sides of the frame and swing the bottom
out to clear. Lift up and forward to disengage from the top. Place
the glass frame assembly in a safe place to avoid damage.
3) Carefully remove the wrapped log set and brick panels from
inside of the firebox and set aside, taking care not to damage
them. Remember, the logs and panels are extremely fragile!
4) The burner assembly has been packed separately to avoid
damage during shipping. Remove the entire assembly from the
packaging and place in the bottom of the firebox by tilting it
slightly forward. Be sure to align the two studs on the side of the
burner with the holes provided in the firebox bottom. (See Fig. #
23). Fasten in place with the two wing nuts provided.
5) Place the self-adhesive label into the blank box provided on the
rating label to designate the type of gas the appliance is con-
nected to.
BRICK PANELS INSTALLATION
1) Remove the brick panels from packaging.
2) Place the back brick panel against the rear of the inside of the
firebox so that the largest row of bricks is on the bottom.
3) Place one of the side panels into the right side of the firebox, brick
side facing in.
4) Place the other side panel into the left side of the firebox, brick
side facing in.
Fig. # 23
Fig. # 22
f i r e - p a r t s . c o m