User’s Manual
10
16.
Move to
Serial (RS232 / RS485)
, and check the box and click the
Set up Serial
when the DVR is controlled
remotely using the serial communication signals. Select the DVR's COM port to use from the drop-down list.
Click the
Set up port...
button, and set the
Baud rate
from 300 to 256,000. Select
Parity
from
None
,
Even
or
Odd
parity. Select
Data bit
from
7 bit
or
8 bit
format. Select
Stop bit
from
1 bit
or
2 bits
from the drop-down
list. Move to
Device ID
, and set the device ID number from 0 to 127 using the slide bar. See
Appendix 6 –
Protocol for Remote Controlling DVR
for details.
17.
Move to
Network
, and check the box and click the
Set up Network
when the DVR is controlled remotely using
the network connections. Enter the
Network Port
number.
18.
Move to
HDD usage
, and select either
Once
or
Recycle
. When
Once
is selected, the DVR stops recording
when the hard disk drive is full. When
Recycle
is selected, the DVR continues recording when the hard disk
drive is full by overwriting the oldest video.
19.
Click the
Set up Time Sync…
button, and set up the time synchronization if required. See
Appendix 7 –
Time
Synchronization
for details.
20.
Click the
Change Signal…
button, and set the camera input signal to each camera number.
21.
Click the
Note…
button, and set up the note function. The user can add or delete notes. If you want to read the
note, select the line and click the
View
button. Click the
Load
button to load the saved note, the
Save
button to
save the current note, and the
Text Save
button to save the current note to the text file.
22.
Click the
Set up backup...
button, and set up backup information. See the
SmartBackup
section.
23.
Click the
Set up pager...
button, and set up pager information. See the
SmartPager
section.
NOTE:
The
Set up pager...
button will be activated if you set up SmartPager to start in the SmartGuard setup.
24.
Click the
Set up Web Server...
button, and set up an IIS(Internet Information Services) for the WebGuard
program.
25.
Click the
Load...
button if you want to load typical settings. Click the
Save...
button if you want to save settings.
Click the
Default
button if you want to load default settings. You can save your changes by clicking the
OK
button. Selecting
Cancel
exits the dialog box without saving the changes.
NOTE:
Only the administrator level user can use the Load, Save and Default buttons.
