Pace TDC777D, Руководство по установке

Страница: 32 / 37

32
TDC777D INSTALLER’S MANUAL (502-3432110)
MAKING USER SETTINGS (cont.)
Restoring the factory default settings
If you wish, you can restore the user settings and subtitle settings to their factory defaults. All the changes you
have made will be lost and the settings will revert to those that were programmed in the factory. The factory
settings are:
USER/SUBTITLE SETTINGS menu item Options Factory default setting
TV Aspect Ratio – 16:9
TV Display Capability 1080p24 Pass
1080p30 Pass
1080i
720p
480p
480i
No
No
Yes
No
Yes
Yes
Auto Pillarbox – No
Closed Captions – Off
Configure Captions Various All Auto except Hi Def CC, which
is Service 1
Front Panel Settings Standby Brightness
Viewing Brightness
IR Receiver
Std
High
On
Hard Disk Sleep Mode (Standby Sleep Mode) – Yes
HDMI Settings Audio Output Mode
Disable Auto Detect
Auto
No
Subtitles – Off
Subtitle Language – English
The flow diagram (right) shows how you use the arrow , SELECT , and POWER buttons on the set-top’s front
panel to change the display and make the settings. See also the instructions below.
If you have not done so already, put the set-top into User Settings mode, as described on page 25.
1. Press the D button until the front panel shows “reSt” (short for “ rest ore factory settings”), as shown right,
and Restore Defaults is highlighted on the PACE USER SETTINGS menu.
2. Press the R button.
“YeS” appears on the set-top’s front panel and the message: “Restore Default. Press OK to confirm”
appears on the TV screen. (If, at this stage, you no longer wish to restore the factory settings, press the
L
button.)
3. To confirm and restore the factory settings, press the SELECT button.
The factory settings are restored, and the PACE USER SETTINGS menu reappears.
4. If you want to continue changing the settings, see the sections from page 25 onwards. If you have finished
changing the settings, press the
POWER
button. The set-top then switches on with the restored settings.
SELECT
SELECT
SELECT
NOTE
If the set-top and HDTV are
connected via a standard HDMI
cable, the HDTV may pass
information about the required
settings back to the set-top (see
page 26). If you wish to restore
the set-top’s settings to those
created by the HDTV, you must
disconnect the HDMI cable from
the set-top before you restore the
factory default settings. When you
reconnect the HDTV to the set-top
via the HDMI cable, the HDTV will
pass back the information again.
Always turn off the set-top, wait
60 seconds, then disconnect the
set-top from the wall AC outlet
before you connect or disconnect
any other equipment to or from its
rear panel.