Pace DC700X, Руководство оператора

Страница: 22 / 44

20
About User Settings
Your installer should have made the correct settings to make sure your set-top is compatible with
your HDTV or TV. However you may wish to change some settings, for example if you purchase a
new HDTV. You can make the following settings and you can also reset them to the factory defaults.
• TV Aspect Ratio (the screen’s width-to-height ratio, or shape)
• TV Display Capability (screen resolution)
• Auto Pillarbox
• Closed Captions
• Front Panel Settings
• Hard Disk Sleep Mode (for energy saving)
• HDMI Settings
You use the buttons on your remote control to make the settings using on-screen menus. However,
please note that, until your set-top has been set up to match the display capability of your HDTV, these
menus may not be visible. If this is the case, refer to page 23.
Putting your set-top into “user settings mode”
1. Make sure that your set-top is turned on ( POWER light is green).
2. Press the
POWER
button on your remote control, then, within 1 second, press the
MENU
button.
You should see the PACE USER SETTINGS menu, shown right, on your TV screen.
3. When you have finished making changes (see pages 21 to 29), press the
POWER
button to
remove the PACE USER SETTINGS menu and return to normal viewing.
POWER light
MAKING USER SETTINGS
PACE USER SETTINGS
TV Aspect Ratio
TV Display Capability
Auto Pillarbox
Closed Captions
Front Panel Settings
Hard Disk Sleep Mode
HDMI Settings
Restore Defaults
Select[OK] Exit[POWER]