P.S.I TireView, Руководство по установке и обслуживанию, Страница: 30 / 35

Section 1 - TireView
™
TPMS Instruction Manual
5. Loosely install the inside tire cap sensor and the outside tire cap sensor onto the flow-thru bulkhead fitting
valve stems. Make sure the cap sensors are installed in the correct position per the INSIDE and OUTSIDE
labels on the flow-thru bracket. See
Figure 18
,
Figure 19
, and
Figure 20
.
CAUTION: DO NOT OVERTIGHTEN THE SENSOR CAPS. DAMAGE TO THE SENSOR CAP
AND THREADS CAN OCCUR.
6.
Hand-tighten the cap sensors until they bottom out, and then slightly twist the cap sensors to fully seat
them.
TireView ™ TPMS Flow-thru Bracket Installation
Note: Confirm that the tire valve stems are approximately 180° opposite of each other.
Note: Tractor and trailer flow-thru brackets have a slightly different appearance, but the installation is similar for
each. The tractor (R-spindle) flow-thru bracket will require 2 Nylock
®
half nuts to mount to the axle cap studs. The
trailer (N-spindle and P-spindle) flow-thru bracket installation is the same. The brackets will use four of the hub cap
mounting bolts to secure to the wheel end. See
Figure 18
,
Figure 19
, and
Figure 20
.
1. Position the flow-thru bracket assembly next to the axle cap and align the flow-thru bulkhead labeled
OUTSIDE with the valve stem of the outside tire. See
Figure 22
.
Figure 22: Outside Flow-thru Bulkhead Alignment with Valve Stem
2. For R-spindle configurations:
a. Mount flow-thru bracket assembly onto the axle cap studs. Install two Nylock
®
half nuts onto the
flow-thru bracket assembly. Torque to 50-60 ft-lbs. See
Figure 23
.
© Pressure Systems International Inc.
All rights reserved worldwide.
30 T004-01 Rev 06-19