O
ZRAY
Pollux Small Series – 16M Camera
Page
17
of
40 Manual 1.2
3.3
LED Status Indicator
A two-color (Red/Green) LED on the back of the camera is used to indicate
operational status. Table 7 summarizes the operating states indicated by the LED.
LED State
Description
Slow flash alternate Red
Booting (It takes for about 6 s)
Slow flash Green
Booting is completed
Table 7.
LED status
3.4
Installation
The following instructions assume that you have installed a Camera Link Frame
Grabber in your computer including related software. Procedures below also
assume that you may attempt to configure a link between a camera and Camera
Link Frame Grabber by using two Mini Camera Link (MiniCL) SDR26 cables or two
Mini Camera Link (MiniCL) SDR26 PoCL cables. To connect the camera to your
computer, follow the steps below :
1. Make sure that the power supply is not connected to the camera and your
computer is turned off.
•
Go on to step 2 if you are using a power supply.
•
Go on to step 3 if you are using a Power over Camera Link (PoCL) Frame
Grabber.
2. If you are using a power supply:
a.
Plug one ends of the other two Mini Camera Link (MiniCL) SDR26 cables into
CH1 and CH2 of the Camera Link Frame Grabber and the other ends of the
Mini Camera Link (MiniCL) SDR26 cables into the CH1 and CH2 of the MiniCL
SDR26 Connectors on the camera respectively.
b.
Connect the plug of the power adapter to the 6-pin power input receptacle on
the camera.
c.
Plug the power adapter into a working electrical outlet.
Содержание pollux PX12M64MCL
Страница 1: ......
Страница 19: ...OZRAY Pollux Small Series 16M Camera Page 19 of 40 Manual 1 2 Figure 10 Installation using PoCL ...
Страница 33: ...OZRAY Pollux Small Series 16M Camera Page 33 of 40 Manual 1 2 ...
Страница 37: ...OZRAY Pollux Small Series 16M Camera Page 37 of 40 Manual 1 2 Figure 22 Setting ROI at Pollux terminal ...