CARING FOR THE ENVIRONMENT
TROUBLESHOOTING
Spare parts can be ordered from the Special Orders Desk at
your local Bunnings Warehouse.
For further information, visit www.ozito.com.au or contact
Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
SPARE PARTS
• Keep air intake clean and air vents free of debris to avoid overheating the motor.
• Do not use cleaning agents to clean the plastic parts of the tool.
A mild detergent on a damp cloth is recommended. Water must never come into contact with
the tool.
• If the blower vibrates abnormally, stop motor immediately. Abnormal vibration usually indicates
a mechanical problem continued operation could lead to injury or damage.
• No lubrication is necessary as the motor is equipped with lifetime-lubricated bearings.
WARNING!
ALWAYS ENSURE THE TOOL HAS
COMPLETELY STOPPED AND THE BATTERIES ARE
REMOVED PRIOR TO ANY MAINTENANCE.
Problem Cause
Remedy
Blower is not
starting
Battery is low in charge.
Charge battery
Battery not inserted
properly.
Insert battery pack correctly.
Blower is not
operating at
full capacity
Variable speed set low.
Inspect variable speed dial and increase as
necessary.
Motor stops
while blowing
Battery has no power.
Charge battery.
Turbo boost
will not
operate.
Batteries fitted are 1.5Ah
or 2.0Ah.
Insert batteries 3.0Ah, 4.0Ah or 5.2Ah.
Note: Ozito Industries will not be responsible for any damage or injuries caused by the repair of the
blower by an unauthorised person or by mishandling of the blower. This tool is designed for DIY use
- use in commercial or industrial environments will void the warranty.
Read instruction manual
Do not use in the rain or leave the blower outdoors while raining.
Keep bystanders away. Do not operate whilst people especially
children or pets are in the area.
Wear eye and ear protection.
Regulator compliance mark
Keep hands out of the openings while the tool is running
Sound pressure level
94
DESCRIPTION OF SYMBOLS
MAINTENANCE
The tool is equipped with the battery protection system, which helps to ensure a long service
life.
The output power automatically cuts off during operation when the tool and/or battery are
placed under the following situations:
• When the tool is overloaded:
If this occurs, remove and reinsert the batteries then pull the on/off trigger again to restart.
• When the remaining battery capacity becomes low:
Recharge the battery pack.
Note:
The battery protection system does not in any way damage the tool.
Note:
The indicated capacity may be lower than the actual level during use or immediately
after using the tool.
Note:
Always use 2 batteries of the same capacity and same charge state with the jet
blower.
BATTERY PROTECTION SYSTEM
Power tools that are no longer usable should not be disposed of with household
waste but in an environmentally friendly way. Please recycle where facilities exist.
Check with your local council authority for recycling advice.
Recycling packaging reduces the need for landfill and raw materials. Reuse of
recycled material decreases pollution in the environment. Please recycle packaging
where facilities exist. Check with your local council authority for recycling advice.