![background image](http://html1.mh-extra.com/html/york/sunline-k4eu120a50a/sunline-k4eu120a50a_installation-instruction_3537677001.webp)
GENERAL
These completely assembled blower units are manufac-
tured under ISO 9002 Quality System Certification and
include a well-insulated cabinet, a DX cooling coil with
copper tubes and aluminum fins, an expansion valve, a
distributor, throwaway filters, a centrifugal blower, a
blower motor, a blower motor contactor, an adjustable
belt drive and a small holding charge of Refrigerant-22.
Blower motors and adjustable drives are factory-
installed on all units.
The units are shipped in the vertical position with a vertical air
discharge. The blower section can be repositioned as shown in
Figure1 for horizontal applications.
REFERENCE
Additional information for the accessories on this equip-
ment is available in the following instructions:
•
Electric Heater - 550.13-N10.1V
•
Supply Air Plenum - 550.13-N10.2V
•
Return Air Grille - 550.13-N10.3V
•
Base - 550.13-N10.4V
•
Hot Water & Steam Coil - 550.13-N10.7V
Renewal Parts:
•
Refer to Parts Manual for complete listing of replacement
parts on this equipment.
All forms may be ordered from:
Publications Distribution Center
Unitary Products Group
P.O. Box 1592, York, PA 17405
INSPECTION
As soon as a unit is received, it should be inspected for
possible damage during transit. If damage is evident, the
extent of the damage should be noted on the carrier's de-
livery receipt. A separate request for inspection by the
Installer should pay particular attention to the words:
NOTE, CAU-
TION
and
WARNING
. Notes are intended to clarify or make the in-
stallation easier. Cautions are given to prevent equipment damage. Warnings are given to alert installer that personal injury
MODELS K5EU090A50A & K4EU120A50A
(WORLD 50 HZ)
035-12122
®
INSTALLATION INSTRUCTION
SUNLINE™ SPLIT-SYSTEM
EVAPORATOR BLOWERS
(AIR COOLED)
Supersedes: Nothing
550.39-N4YI (894)
CAUTION
THE ENCLOSED INSTALLATION INSTRUCTIONS AND ANY APPLICABLE
LOCAL, STATE, AND NATIONAL CODES INCLUDING, BUT NOT LIMITED
TO, BUILDING, ELECTRICAL, AND MECHANICAL CODES.
THIS PRO DUCT M UST BE INSTALLED IN STRICT COMPLIANCE W ITH
WARNING
OPERATION OF THE PRODUCT COULD CAUSE PERSONAL INJURY
O R P R O P E R T Y D A M A G E .
INCORRECT INSTALLATION MAY CREATE A CONDITION W HERE THE