10
OPERATION (cont.)
Cleaning
Warning:
Do not pour or spray water directly into or over the motor cover.
IMPORTANT:
Never put any of your body parts (including hands) inside the drum
while it is rotating.
IMPORTANT:
Wipe off any external material on the motor cover. Do not use
petrol, turpentine, lacquer or paint thinner, dry cleaning fluids or similar products.
The use of chemical products or solvents may damage the motor cover.
Thoroughly clean the mixer at the end of each days operation.
Keep your mixer clean. The slightest trace of material left in the drum will harden
and attract more material each time the machine is used.
Dried cement should be scraped out of the drum.
DO NOT throw bricks into the mixer drum to clean it out.
DO NOT beat on the drum with a shovel, hammer or other tools to break up
accumulation of dried cement mix as the cement mixer may be damaged.
The drum may be scoured for approximately 2 minutes, using a 1” stone and
water mixture. After this, discharge the stone/water mixture and hose down the
drum assembly inside and out.
The IP55 protection clad construction of the mixer enables the DRUM ASSEMBLY
ONLY to be hosed down safety. Avoid getting water on the motor housing, DO
NOT wet the motor.
1. Ensure that the power is disconnected from the tool prior to any maintenance
being carried out.
2. Ball bearings are packed with grease at the factory. No further lubrication of
bearings is required.
3. Lubricate all moving parts periodically. Wipe and other parts with an oily cloth
to keep corrosion to a minimum.
4. During normal use, painted surfaces can loose their coating during the mixing
process. Wipe all exposed surfaces regularly with an oily rag to prevent
corrosion. (Note: Rust is not a warrantable claim.)
5. Keep air vents clean of dust and dirt.
6. Remove dust and dirt from the cement mixer regularly with soft cloth, brush or
compressed air. Use a mild detergent and a soft cloth to clean plastic parts.
7. If the power cord is damaged, have it replaced by an electrician or a
power tool repairer.
8. Regularly check that all bolts, screws and nuts are securely fixed as these could
work loose during normal operation.
9. Check and maintain tyre pressure @ 206kPa (30psi)
Note:
Ozito Industries will not be responsible for any damage or injuries caused
by the repair of the tool by an unauthorised person or by mishandling of the tool.
MAINTENANCE