BATTERY STATUS
MODE STATUS
25%
50%
75%
ERROR
100%
Charging time/hours =
Battery capacity in Ah
Amperes (charging current)
80%
2 h
Ah
5 h
15 h
30 h
4
10
30
60
Charging time/hours =
Battery capacity in Ah
Amperes (charging current)
80%
2 h
Ah
5 h
15 h
30 h
4
10
30
60
1. Red Positive Terminal Clamp (+)
2. Black Negative Terminal Clamp (-)
BATTERY CHARGER
KNOW YOUR PRODUCT
1. AUTOMATIC CHARGING
SETUP & PREPARATION
5. Mode Status LED’s
6. Battery Status LED’s
7. Error LED
1
2
3
4
5
6
7
WARNING!
READ AND UNDERSTAND THE WARNINGS
BEFORE SETUP AND CHARGING.
ONLINE MANUAL
Scan this QR Code with your mobile
device to take you to the online manual.
WARNING!
DO NOT USE FOR CHARGING LITHIUM ION
PHOSPHATE RECHARGEABLE BATTERIES (E.G. LiFePO4)
OR OTHER LITHIUM RECHARGEABLE BATTERIES.
3. LED’s
4. Mode Button
The battery charger is a microprocessor controlled automatic
charger, it is suitable in particular for charging maintenance-free
batteries and for the long-term charging and maintenance-
charging of batteries which are not in constant use, e.g. for
classic cars, recreational vehicles, lawn tractors and alike. The
integrated microprocessor enables charging in several steps. The
final charging step, maintenance charging, maintains the battery
capacity at 95–100% and therefore keeps the battery fully charged
at all times. The charging operation does not need to be monitored.
However, do not leave the battery unattended if you charge it over
an extended period of time, so that you can disconnect it from the
mains power supply in the event of a fault in the charger.
The battery charger is designed for mobile use only and not for
installation in caravans, mobile homes or similar vehicles. The
battery charger cannot be used as a buffer power supply, e.g.
while changing a battery. Do not expose the charger to rain or
snow.
Calculating the Charging Time
The charging time
depends on the
charge status of the
battery. If the battery
is fully discharged, the
approximate charging
time up to approx.
80% charged can be
calculated using the
following formula:
Note:
The charging current should be 1/10 of the battery capacity.
Overload Cut-Out
The battery charger is equipped with electronic protection against
overload, short circuit and swapped poles. One or more fine fuses
are also fitted. If the fuse suffers a defect it must be replaced by
a new fuse with the same amp value. If necessary, please contact
Ozito customer service.