OWL The Otter SGC-1, Руководство пользователя

Страница: 11 / 20

U
sing the System
SECTION 2
7
Operating
1. The caster consists of two
adjustable ends and two side pieces
with a cut out railing. The railing
is open at one end so that long
glass can slide past the length of
the caster. The opposite end has
a stop cut into the sides so that
the bottom plate is held in position.
Loosen knobs on the ends of the
caster and place glass into unit.
Slide the sides of the caster togeth-
er to tightly fit the glass plate.
Tighten knobs.
2. Making sure that the casting area is level, place the blank, longer glass
plate into the caster, pushing it to the end with the stops. The rail it is
sitting on is slightly lower than the rail on the other end of the unit.
3. Moisten spacers with drops of water and place them flush to the edge
of the glass against the side of the rail. Moistening helps to keep the
spacers from moving while sliding the notched plate over them during
casting.
4. Place the notched top plate on top of the blank plate so that the two
overlap by about one inch. The side rail will hold the top plate above
the bottom blank plate. This plate should slide freely up to the top of the
blank plate. Have your gel solution ready at this point.