Maintenance
313294D
15
Clean Slip-Fit Polycarballoy Mix
Module
1.
Follow Pressure Relief Procedure, page 10.
2.
Flush Gun, page 14.
3.
Remove mix module, page 20.
4.
See F
IG
. 3 and F
IG
. 4. Clean mix module impinge-
ment ports (IP) with appropriate size drill (supplied).
See identification chart under Accessories, page
28.
NOTE:
•
Component B (red) impingement ports, at rear of
mix module, are angled toward front of gun. See
F
IG
. 4.
•
When cleaning do not scratch the sealing edges
and ports.
5.
Reassemble, page 20.
NOTICE
To avoid damaging mix module, do not force drill bits
when cleaning impingement ports. Some ports are
offset or angled.
F
IG
. 3: Cleaning Component A (White) Ports
TI3863a
F
IG
. 4: Cleaning Component B (Red) Ports
TI3862a
