14
Changing Light Bulbs
1. Disconnect power to door opener.
Open powerhead light cover(s) by pressing in on upper locking tab and swing down.
•
Replace old light bulb(s) with new.
•
Use 100 Watt MAX incandescent bulbs or the CFL or LED equivalent.
•
Close powerhead light cover(s).
2. Reconnect power to door opener and close lens cover.
•
Test light operation.
NOTE:
Use of LED bulbs may reduce the range of your remote controls.
Visit www.OverheadDoor.com for more information on specific LED
bulbs produced for garage door openers.
F. Light Bulb Replacement
WARNING
!
•
Use extreme caution when working from a ladder or step
stool or serious injury can occur.
•
When replacing light cover, make sure wires are not pinched
or near moving parts.
•
Use only properly rated incandescent, LED or CFL light bulbs.
•
DO NOT use bulbs with a rating greater than 100 Watts*.
•
Use A19 size light bulbs. DO NOT use bulbs having a short
neck.
AVERTISSEMENT
!
•
Faire particulièrement attention lors de travaux effectués
depuis une échelle ou en escabeau.
•
En referment le couvercle de l’éclairage, s’assurer que les fils
ne sont ni coincés ni près des pièces mobiles.
•
Utilisez uniquement incandescence correctement classé, LED
ou des ampoules fluocompactes.
•
NE PAS utiliser des ampoules avec une note supérieure à 100
Watts*
•
Utilisez A19 ampoules de taille. NE PAS utiliser des ampoules
ayant un cou court.
MAINTENANCE & ADJUSTMENTS
Speed Adjustment
10
Speed Settings (DC Models only)
Speed settings are pre-programmed at the factory
for the maximum speed. Speed settings should not need
adjustment with this unit. However, travel speed for the
opener can be adjusted to a slower speed in both the Open
and Close directions, to minimize wear on heavier sectional
doors.
There are three speed settings available for sectional doors.
Please note that speed may be affected by door weight and
balance, along with condition of door components and tracks.
G. Adjustment Guides
* Overhead Door LED light bulbs are designed
to reduce or eliminate reduced remote range
issues caused by common LED bulbs. They
also offer better product life by making them
resistant to vibration caused by the opener, and
cold or damp weather. See website for details
at www.OverheadDoor.com. recommendations
for LED bulbs.
