19
PRGM
SET
PRGM
SET
PRGM
SET
PRGM
SET
CLEARING MEMORY OF REMOTES
NOTE
:
Clearing memory of remotes from the powerhead
will clear ALL programmed remotes, wireless keypads and
vehicle transmitters. The opener will no longer recognize
any signal from any remote device, including a missing
remote device.
All remaining (or recovered) remotes, vehicles and
wireless keypads MUST be reprogrammed.
NOTE
:
The garage door opener will operate normally
using the wall console.
1. Press and hold the SET/PRGM button on the
opener for two seconds.
•
The ROUND LED will turn BLUE.
•
The LONG LED will then flash PURPLE.
2. Press and hold the UP & DOWN buttons at the
same time until both LEDs turn off.
•
Both opener LEDs will flash and turn off
indicating that all remotes have been erased.
3. Press any remote button.
•
The opener should NOT run.
To deprogram the same remote for other garage door
openers, repeat the steps above using one of the other
remaining remote buttons.
1. Enter Programming Mode
Solid Blue
PRESS 2
SECONDS
& RELEASE
Flashing Purple
2. Press and Hold + (UP) & - (DOWN) Buttons
3. Test Remote
Release when LEDs turn off
OPTIONAL PROGRAMMING & ACCESSORIES
6
Flashing
Blue
OFF
