20
PRGM
SET
B. Press the chosen HomeLink button for two seconds and release. Press
that same button again for two seconds and release. The long LED
will flash blue and then turn off.
C. Press the HomeLink button a few more times until door moves.
NOTE
:
For additional instructions, see the motor vehicle manual,
www.homelink.com or visit www.OverheadDoor.com
Step 1 Clear HomeLink
Clear HomeLink by pressing and
holding down the first and third buttons
until the indicator on the HomeLink blinks
slow and then fast for 20 seconds; then
release both buttons.
NOTE:
Clearing the HomeLink will remove all previously
programmed garage door openers.
Step 2 Train HomeLink to the Overhead Door Remote
Choose the button on the HomeLink that will be used to open the door.
NOTE
:
Hold the Remote two inches from the HomeLink button.
Hold down the remote button. While holding, press and hold the chosen
HomeLink button.
Hold down both buttons until the indicator on the HomeLink blinks slow
then fast. Once it blinks, release both buttons.
Step 3 Program HomeLink to the Overhead Door Opener
A. Press
PROGRAM SET
button two seconds until the round LED turns
blue, then release. The long purple LED will blink.
Programming HomeLink® System
Programming Car2U® System
Step 1 Clear Car2U to default settings
The default setting for the Car2U system is:
• Button 1 = Overhead Door® Manufactured Openers
• Button 2 = LiftMaster® Manufactured Openers
• Button 3 = Wayne Dalton® Manufactured Openers
A. Press and hold buttons 1 and 3 for 20 seconds or until all three LEDs
begin to flash.
B. Release both buttons. The Car2U system is now set to the Factory
Default settings
NOTE
:
Clearing the Car2U remote will remove all previously programmed
garage door openers.
Step 2 Program Car2U to the Overhead Door Opener
A. Press
PROGRAM SET
button two seconds until the round LED turns
blue, then release. The long purple LED will blink.
B. Press the designated Car2U button for two seconds and release. Press
that same button again for two seconds and release. The long LED will
flash blue and then turn off.
C. Press the Car2U button a few times more until door moves.
Step 3 Changing Factory Default Button for an Overhead Door
Opener
A. Press and hold buttons 1 & 3 for
ONE SECOND
and release—all three
LEDs will light solid red.
B. Press and hold the button (2 or 3) to change it to Overhead Door—the
corresponding LED will flash. While continuing to hold that button,
press and release button 1. Press and release button 1 again.
C. Release the button being held in step B and wait for the LED to stop
flashing. This button is now set for Overhead Door. Repeat Step 2 for
second Opener.
NOTE
:
For additional instructions see the motor vehicle manual,
learcar2u.com or visit www.OverheadDoor.com
VEHICLE PROGRAMMING
PRGM
SET
