40
082809
Mounting Hardware and Installation
The adjustable rack installation hardware is specially designed to speed
collector installation. This hardware consists of four Quick-Lock collec-
tor clamps for the rear top hinge, two Quick-Lock collector clamps with
locking screws for the front bottom hinge, four triangle brackets (collector
feet), two
aluminum square tube strut for collector legs, bolts, nuts and washers.
(See page 33).
After locating the mounting points for the collector feet, the base plate and
fl ashing should be installed (See page 38).
Install the triangle brackets on top of the fl ashing using the neoprene-
bonded washer and stainless locking nut.
The rear struts should be cut and drilled to the desired length from
Table 1.
Quick-Lock collector clamp into front foot
Attach two Quick-Lock collector clamps with locking screws to
bottom of the collector. Keep the locking screws loose. Secure
the bottom Quick-Lock clamps on the collector and drop the
clamp into the triangle bracket using the bolt, washer, and nut
provided. Tighten locking screws after collector is set on the
triangle brackets. See diagram 1.
Attach the four Quick-Lock collector clamps to the top of the
collector. Using two Quick-Lock clamps per collector leg, bolt
the collector leg (mounting strut) to the top of the collector.
Attach both collector legs.
Raise the collector and bolt the bottom of the collector legs to
the collector foot with the bolt, washer, and nut provided.
See diagram 2.
Square up the collector legs and tighten all the nuts and bolts at
the collector feet and the rear collector hinge.
front hinge Diagram 1
rear hinge and strut Diagram 2
