Oval TF1015-P11G-11 A Series, Инструкция по эксплуатации

Страница: 7 / 32

S-93--E
How to Change Display Orientation
If power is supplied, shut it off. (Make sure
nothing appears on the LCD).
Take off four set screws (3 × 14) securing the
upper case to the transmitter and carefully
open the upper case (Fig. 5.2).
If a 180 deg. turn is your option, turn the upper
case the other way with lead wires intact (Fig.
5.3).
To turn 90 deg. clockwise or counterclockwise
follow the steps given below.
Take off four set screws (2.6 × 8) holding the
display board in place and remove the display
board (Fig. 5.5).
Remove four spacers (white rings) attached to
the bosses that have secured the display board
in place (Fig. 5.6).
Extract the top panel and put it onto the upper
case then in the different orientation.
Install the removed spacers over the bosses.
Place the display board in line with the top
panel and secure it with four screws (2.6 × 8
with tightening torque 45cN ･ m). (Align the
opening in the top panel with the mating LED
on the display board).
Make certain that O-ring fits in the groove
of lower case and, exercising care against
pinched cables, secure the upper case with
four screws (3 × 14 with tightening torque of
60cN ･ m). Tighten them in an alternating order
to ensure even tightening (Figs. 5.7).
Display
Board
Fig. 5.5
Setscrew
(4 PLC'S)
Fig. 5.4
3-wire
Cable
Display
Board
Setscrew
(4 PLC'S)
Upper Case
10-wire Cable
O-Ring
Cable Connectors
Lower
Case
Fig. 5.3
Turn the upper case 180
°
, with cables intact.
Upper
Case
Fig. 5.7
Upper Case
Setscrew
(4 PLC'S)
Fig. 5.2
Upper Case
Setscrew
(4 PLC'S)
Top Panel
Bosses (4 PLC'S)
Spacer
(4 PLC'S)
Fig. 5.6
NOTE: Do not take out the screws fixing amp
board on lower case in any case.