Oval TF1015-P11G-11 A Series, Инструкция по эксплуатации

Страница: 18 / 32

S-93--E
Top row: Parameter name
Middle row: Unit of numerical value
Bottom row: Settable range
Factory default settings
Nominal size
15mm 20mm 25mm 40mm 50mm
Alarm setting
L/min (normaI)
0 to 99999
0 00 00 0
Alarm hysteresis
L/min (normal)
0 to 99999
0 3 3
Alarm status
Ho, HS, Lo, LS
LS LS LS LS LS
Alarm setting
L/min (normal)
0 to 99999
00 00 00 000 000
Alarm hysteresis
L/min (normal)
0 to 99999
0 3 3
Alarm status
Ho, HS, Lo, LS
HS HS HS HS HS
Low limit in alarm immunity range
L/min (normal)
0 to 99999
0 3 3
Alarm immune time
Seconds
0 to 99
3 3 3 3 3
Yen conversion factor
Yen m
3
(normal)
0 to 999.999
.000 .000 .000 .000 .000
Pulse weight
L (normal)
0.0 to 9999.99
0. 0. .00 .00 .00
Pulse width
msec
to 0
3
Cutoff
※
L/min (normal)
0 to 99999
9 3 3
Analog full scale
L/min (normal)
0 to 99999
00 00 00 000 000
Analog Damping
sec
0 to 99
0 0 0 0 0
Backlight setting
On, EC, OF, SL
On On On On On
8.3 Default Parameter Settings
Parameters are set to the following default settings before shipment from the factory:
NOTES:
※
: Cutoff set value must not be changed in other than the following cases.
() When output is given though the flow is stopped (
※
).
Set the cutoff value a little greater than the output value at that time.
() When you want to measure the flowrate of the area lower than the cutoff value, set the
cutoff value lower than the desired flowrate.
Under some condition, the difference at this area may be greater depending on the offset
value of the zero point. Therefore, adjust zero point while the flow is stopped (
※
) as
necessary.
※
The stoppage of flow refers to the status where the valve at the lower stream of this unit is
fully opened under the process condition in use and there is no leakage from the valve.