Oval EL0137, Инструкция по эксплуатации

Страница: 28 / 38

E-126-3-E
2
10.7 Procedure for setting parameter
The setting of parameter can be changed following the procedure shown below.
(1) Push switch long in "measurement mode" to enter "confirmation mode".
(2) Operate , , and switches to display the parameter to be changed.
(3) Push switch to enter "parameter setting mode".
(4) The program indicator will start flashing.
(5) Carry out the setting using and switches.
(6) After the input is finished, push switch to enter "confirmation mode".
(7) Push switch long to return "measurement mode".
* If the operation is left for 20 seconds in the status (4) without any key operation, the status will return to (2).
PROG
SELECT
PROG
PROG
CLEAR
PROG
CLEAR
SELECT
PROG
Fig. 10.2 Flow of change of parameter setting
Measurement mode
(normal mode)
Confirmation mode
Parameter
setting mode
(1) (2) (3)
(4) (5)
(6)
(7)