8
9
6.2 Switch off the cool box
•
Empty the cool box.
•
Switch off the cool box.
•
Pull out the cable from the socket.
If you do not want to use the coo box for a longer period of time.
•
Leave the device cover slight open, this will prevent odor build-up.
6.3 Defrost the cooling device
Humidity can form frost in the interior of the cooling device or on the vaporiser, and this will
reduce the cooling capacity of device. Defrost the cooling device in good time to avoid this.
NOTICE! Danger of damage!
Never use hard or pointed tools to remove ice or to loosen objects which have frozen in the cool box.
Process the following step to defrost the cool box
•
Take out the contents of the cool box.
•
If necessary, place them in another cooling device to keep them cool.
•
Switch off the device.
•
Leave the cover open.
•
Wipe off the defrosted water.
7. CLEANING AND MAINTENANCE
7.1 Replacing the DC plug fuse
•
Pull off the adaptor sleeve from the DC plug.
•
Unscrew the screw out of the upper half of the housing.
•
Carefully raise the upper half of the housing from the lower half.
•
Take out the contact pin.
•
Replace the detective fuse with a new fuse with the same type and rating
•
Re-assemble the plug in the reverse order.
7.2 Cleaning the cooling device
•
Occasionally clean the device interior and exterior with a damp cloth.
•
Make sure that the air inlet and outlet vents in the device are free of any dust and dirt,
so that heat can be released and the device is not damaged.
WARNING!
Always disconnect the device from the power supply before you clean and service it.
NOTICE! Risk of damage
•
Never clean the cool box under running water or in a dish water.
•
Do not use abrasive cleaning agents or hard objects during cleaning as these can damage the
Cool box.
8. TROUBLESHOOTING
9. DISPOSAL
•
Place the packaging material in the appropriate recycling waste bins wherever possible.
•
If you wish to finally dispose your device, ask your local recycling center or specialist dealer for details
about how to do this in according with the application disposal regulations.
Fault
Possible cause
Suggested remedy
Device does not function,
LED light does not glow.
No voltage was detected in
the power supply.
The cool box plug fuse is
defective.
In most vehicles the ignition
must be turned on before
power supplied to the DC
power outlet.
Replace the device plug fuse by
a new one.
The device does not cool
(plug is inserted , “ON” LED is lit).
Defective compressor.
This can only be repaired by an
authorized repair center.
The device does not cool
(plug is inserted, display screen
shows Error Code“E1”).
Please also refer to chapter “5.6
The explanation for the running
code shown in the display
screen”.
Low voltage protection battery
monitor is set too high.
Battery voltage is too low.
Select a lower level for battery
monitor.
Test the battery and charge it if
needed.
When operating the device from
DC outlet. (the ignition is on,
but the device is not work,
the LED light is not on either).
The DC outlet is dirty, this result
in a poor electric contact.
The fuse of the DC plug has
blown.
The vehicle fuse has blown.
If the plug of your device
becomes very warm in the DC
outlet, either the DC outlet must
be cleaned or the plug has not
been assembled correctly.
Replace the fuse in the DC plug,
please refer to the chapter “8.1
Replacing the DC plug fuse.”
Replace the vehicle’s DC outlet
fuse, please refer to your
vehicle’s manual.
The display screen shows the
Error Code and the vehicle does
not cool.
Please refer to “5.6 The
explanation for the running
code shown in the display
screen”.
Please refer to “5.6 The
explanation for the running
code shown in the display
screen”.
This should only be repaired by
an authorized repair center.
