8. Press the cool button
. Decrease the temperature to 12°C.
9. If the temperature reaches the set temperature, then the irrigator is primed. Continue to step
10. If the temperature does not reach 12°C in approximately 3 minutes or,repeat steps
through
11. Turn off the irrigator and unplug from the electrical wall outlet.
12. Check if the water reservoir is full. If not, place the funnel in the refill hole of the reservoir and add additional water.
13. Remove the funnel and replace the internal cover. Tighten the screws to secure.
14. Replace the external cover and tighten screws to secure.
15. Plug in the irrigator into the electrical wall outlet and turn on.
Caution
•
Due to the possibility of freezing during shipment, water must be drained from the reservoir before shipping
the ICS AirCal. See
for draining instructions.
3
ICS AirCal Front Panel
This section describes all operational controls located on the front panel of the ICS AirCal.
3.1
ICS AirCal device on/off
This is a push on/push off switch located on the bottom left of the front panel that applies power to the ICS AirCal. On is
indicated by the illumination of a green LED and the digital display. When the ICS AirCal is first turned on it is in operation
mode.
14
Otometrics - ICS AirCal
3 ICS AirCal Front Panel
