Osprey Talon User Guide
24
<20180425>
Encoder Setup
By default, the encoder setup dialog is presented in its simplified state with the ‘Advanced Settings’ button set to ‘Hide’. The
user can take advantage of pre-set Encode Profiles that configure the advanced settings for you. To see the full range of
available settings set the ‘Advanced Settings’ to ‘Show’.
AutoStart
AutoStart is available for each individual encoder. When AutoStart is enabled that encoder will automatically start as soon as
Talon boots. This is useful for lights-out encoding operations that need to come online automatically in the event of power
outage recovery. Other uses include single purpose encoders that will start on power-up without intervention.
Video Source
The choices in the pull-down menu vary depending upon the Operating Mode you have selected.
In 1x3 MBR mode you may select from the three available input sources. Once selected, the same input will be re-
used for any additional streams.
In 2x2 LC mode the video source for Stream 1 must always be HD/SDI. The source for Stream 2 can be either HDMI or
Composite. (not available on AH models)
In 1x1 3G mode any input can be used. The encoded output will always be the same as the input. This mode is
required for 3G output.
NOTE
: Composite is not recommended in 2x2 Mode.
NOTE
: It is recommended in 2x2 LC Mode that the audio originate either from the SDI source or the Analog source.
16:9
If your input is SD, checking this box will set the aspect ratio of the bitstream to 16:9. If the input is HD this setting is ignored.
Содержание Talon G1H model AH-E23
Страница 1: ...Osprey TALON User Guide...
Страница 3: ...Osprey Talon User Guide 2 20180425...