SECTION 3 - CHASSIS & TURNTABLE
3-42
– JLG Lift –
3120740
18.
Cover shaft splines with an installation sleeve. Install a
new shaft seal (27) with the cup side facing the motor.
Press seal into housing until it bottoms out. Press evenly
to avoid binding and damaging the seal. Install seal sup-
port washer (28) and snap ring (29).
19.
Install remaining plugs and fittings to the housing. Refer
to the drawing below for wrench sizes and installation
torques.
29
28
27
27. Shaft Seal
28. Seal Support Washer
29. Snap Ring
Figure 3-30. Shaft Seal
1/4 in
(45 Nm)
33 ft.lbs.
5/16 in
(85 Nm)
63 ft.lbs.
5/16in
(85 Nm)
63 ft.lbs.
1/4 in
(45 Nm)
33 ft.lbs.
9/16 in
(170 Nm)
125 ft.lbs.
3 mm
(2.03 to 3.39 Nm)
1.5 to 2.5 ft.lbs.
Figure 3-31. Plugs and Fittings Installation
Go to
Discount-Equipment.com
to
order your
parts
