Oshkosh JLG 400S, Руководство по обслуживанию и ремонту

Страница: 405 / 462

SECTION 7 - BASIC ELECTRICAL INFORMATION & SCHEMATICS
3120895 – JLG Lift – 7-3
Current Measurement
•Set up the meter for the expected current range
•Be sure to connect the meter leads to the correct
jacks for the current range you have selected
•If meter is not auto ranging, set it to the correct
range (See multi meter’s operation manual)
•Use firm contact with meter leads
7.3 CHECKING SWITCHES
Basic Check
The following check determines if the switch is functioning
properly, not the circuit in which the switch is placed. A
switch is functioning properly when there is continuity
between the correct terminals or contacts only when
selected.
1. De-energize the circuit.
2. Isolate the switch from the rest of the circuit if possi-
ble. If not possible, keep in mind it may affect read-
ings.
3. Access the terminals to the switch.
4. If the switch has two terminals:
a. Measure resistance across the terminals.
b. Change the switch position.
c. Measure resistance again with the leads in the
same positions. If the meter was reading short, it
should read an open. If the meter was reading
open it should read short.
5. If the switch has more than two terminals, consult
the schematic or switch diagram to determine what
terminals will be connected. The test is similar to
testing a switch with two terminals.
a. Place one meter lead on the common contact
and the other on a different contact in the same
circuit.
b. Cycle through all positions of the switch. The
meter should read short only when the switch
connects the two terminals and open otherwise.
c. If the switch has more than one common contact
repeat the process for that circuit.
Limit Switches
Limit switches are used to control movement or indicate
position. Mechanical limit switches are just like manually
operated switches except that the moving object operates
the switch. These switches can be tested the same way as
a standard switch by manually operating the sensing arm.
Another type of limit switch used by JLG is the inductive
proximity switch, also referred to as a "prox switch". Induc-
tive proximity switches are actuated only by ferrous metal
(metal that contains Iron, such as steel) near the switch.
They do not require contact, and must be energized to
actuate. These types of switches can be used to detect
boom or platform position, for example. These switches
have a sensing face where the switch can detect ferrous
metal close to it. To find the sensing face, take note how
the switch is mounted and how the mechanisms meet the
switch. Test this type of switch as follows:
1. Remove prox switch from its mount.
2. Reconnect harness if it was disconnected for step a,
and turn on machine.
3. Hold switch away from metal and observe switch
state in the control system diagnostics using the
Analyzer. See vehicle or control system documenta-
tion on how to do this.
4. Place sensing face of switch on the object to be
sensed by the switch. If that is not available, use a
piece of ferrous metal physically similar to it. The
switch state in the control system diagnostics
should change.
5. When reinstalling or replacing switch be sure to fol-
low mounting instructions and properly set the gap
between the switch and object sensed.
Figure 7-4. Current Measurement (DC)