Operating instructions for Pool control-40.net filter control unit
Page: 16 (34)
ON/OFF
This button is illuminated when the control unit is on.
Manual operation
This button can be used to switch on the filter pump manually,
independently of the timer. This button is illuminated during manual
operation.
Reset
fault indicator
This button shows a red light if the control unit detects a fault (e.g. motor
protection tripped). The system can only resume normal operation once the
fault indicator has been cleared by pressing this button.
ECO
ON/OFF
This button can be used to switch ECO mode on and off (energy saving
mode).
Pump indicator
light
This indicator light indicates when the filter pump is running.
Heating indicator
light
This indicator light is illuminated when the heating (heat exchanger) is on.
Solar heating
indicator light
This indicator light is illuminated when the solar heating is running.
+
Adjustment
buttons
These buttons can be used to program water temperature, time, timer
settings and backwash times. These buttons can also be used to alter
values in the configuration menu.
Temperature
selection
Use this button to select the water temperature for the swimming pool:
1. Press the button
⇒
the display shows
2. You can now use the
and
buttons to set the temperature you
require in the range 0.1°C to 40°C.
3. To save the required temperature, press the
button again. If
more than 10 seconds pass without any button being pressed when
setting the temperature, the last temperature selected is saved
automatically and the normal operation display reappears.
If a solar sensor is connected to the control unit, you can use this button to
display the current temperature at the solar sensor:
1. Press the
button twice
⇒
the display shows the temperature at
the solar sensor, e.g.
2. To close this display, press the
button again. If more than a
minute passes without any button being pressed, the normal
operation display reappears automatically.
If an air temperature sensor is connected to the control unit, you can use
this button to display the current air temperature:
3. Press the
button three times
⇒
the display shows the air
temperature, e.g.
4. To close this display, press the
button again. If more than a
minute passes without any button being pressed, the normal
operation display reappears automatically.
Setting the time
Use this button to set the actual time:
1. Press the
button
⇒
the display shows:
The
day of the week flashes.
2. Use the and buttons to select whether you want to set the day,
hour or minutes. The relevant text flashes.
3. Use the
and
buttons to make the setting for the currently
flashing text (day, hour or minutes).
4. To save the time, press the button again. If more than 5 seconds
