29
STOVE STOPS FEEDING PELLETS AND SHOWS
WARNING CODE “H”
Possible Causes: Possible
Remedies:
1.
One of the two L-250 automatic high temperature switches has been
tripped.
The L-250 automatic high temperature switches are located on the top and
bottom of the auger housing They send a signal to the control board if the
auger housing overheats. Wait until the stove cools down AND THEN
INSPECT YOUR UNIT. Improper installation, poor maintenance, or a
defective or missing component may be causing the stove to overheat.
Reset the stove and restart it. Call a technician if you get this code again.
*See procedure below to restart the stove.
CODE
BEFORE RESETING
TO RESET
H1, H2, H3
OR H4
Heat exchanger and/or exhaust system
is/are clogged. Refer to the owner’s manual
for maintenance procedures.
Press simultaneously for 2 seconds
and
icons .
*** After 3 attempts, reset is no longer possible. Call SBI technical support.
STOVE STOPS FEEDING PELLETS AND SHOWS
WARNING CODE “d”
Possible Causes: Possible
Remedies:
1. The hopper lid has stayed open for more than 3 minutes
As a security measure, the auger will stop turning and feeding pellets as
soon as the hopper lid opens. It will resume normal operation as soon as
the hopper lid is closed. However, if the hopper lid stays open for more
than 3 minutes, the unit will stop and a code “d” will appear on the control
board. Close the hopper lid. Reset the unit and start it again.
THE STOVE IS RUNNING BUT DISPLAYS WARNING CODE
Possibles Causes:
Possibles Solutions:
Warning generated by a power failure while the stove was
running.
The stove will restart on the initial setting once it cools off.
Note: For a short power failure (less than 5 seconds), the stove will continue to
function at the selected speed.
