45
44
51
1
2
5.2.2
Setting the height
The stabiliser tube is height-adjustable.
Loosen the locking screws (Fig. 50/
➀
),
position the stabiliser tube (Fig. 50/
➁
)
according to the driving wheel. Re-
tighten locking screws.
!
Warning:
To provide sufficient stability from tip-
ping, both stabilisers must be set to
the same height.
5.2.3
Correct stabiliser length:
In order to ensure sufficient support, the
stabilisers must extend beyond the driv-
ing wheel.
5.3 Tread cap
The tread cap (Fig. 51/
➀
) is used by
the carer to tilt the wheelchair when
negotiating obstacles and can be
mounted on the right or left.
5.3.1
Setting the height
To set the height, loosen the locking
screws (Fig. 51/
➁
). Re-tighten locking
screws when adjustment is complete.
50
1
2
5.2 Stabilisers
The stabilisers (Fig. 48) provide increased
stability from tipping and can be swiv-
elled inwards under the seat (Fig. 49).
!
Warning:
In certain situations, stabilisers do not
provide sufficient protection against
overturning.
Therefore never:
▲
Lean the upper body too far back.
▲
Start off too quickly, particularly when
travelling uphill.
☞
Note:
Please observe the advice given in
the booklet "Safety Information for
Mechanical Wheelchairs"!
5.2.1
Swivelling the stabilisers
Push the stabilisers downwards from the
locking device, then swivel them in-
wards under the seat (Fig. 49) until the
locking element engages automatically
at the top.
48
49
