4
PeerCall User’s Manual
message
Enter ID 0-9
will be displayed. User can then enter the one digit
memory ID (0-9); the ten-digit phone number will be stored to the Phone Book and
displayed on the screen.
Press <OK> to start calling. Press <Exit> or hang up the hook put the PeerCall
back to
Standby
mode.
Please note, the number will be stored to the server immediately once entered
completely. In case the link was disconnected, this number will be dropped.
The message
Not Ready...
indicates the PeerCall is off-line (please refer to
section
2.1
). In that case, please follow instructions above and try again.
2.4.2 Retrieve a phone number from the Phone book
In
Standby
mode, the user is able to select a phone number from the Phone book
by holding down the memory ID (0-9, a digit number) for more than two seconds.
The phone number for the selected memory ID will be displayed.
Press <OK> to start calling. Pressing <Exit> or hanging up the Handset will put the
PeerCall back to
Standby
mode.
3. Answer a Call
When someone is calling, the
buzzer will ring
and the display will show the Caller’s ID
number, e.g.
111-666-8888
. Just pick up the Handset or press <OK> to answer the call.
The display will show
Talking...
, the incoming (
) icons will be on, the current time,
hh:mm mo/dy and the elapsed time ee (in minutes) will be displayed.
During the conversation, if the caller hangs up the Handset or presses <Exit>, the
message
End of Talk
will be displayed for two seconds, the PeerCall will then be put
back in
Standby
mode. If the link was disconnected due to transmission difficulties (for
more than eight seconds), the message
Disconnected
will be displayed.
4. Voice Message
4.1 Record a Voice Message
4.1.1
If the Voice Message box is full, you will hear the
Busy Tone
and the display will
show
Msg Box Full
with a
warning (Buzzer) sound
.
The user can hang up the Handset or press <Exit> button to put PeerCall back to
Standby
mode.
4.1.2
If the Voice Message box is available, the user will hear a Greeting Message pre-
recorded by the receiver. The display will show
Greeting...
in the meantime. In
case the receiver has not pre-recorded a Greeting Message, the user will hear the
default Greeting Message instead:
Hi, I’m not available at this moment. Please leave your message after the beep.
4.1.3
The caller can leave a message after hearing a
beep
.
There is a 30 second timer counting down while the text displays
Recording...
4.1.4
The recording will end either when the caller hangs up the phone, presses the
<Exit> button, or the 30 second timer is up with a
warning (buzzer) sound
. The
PeerCall will then go back to
Standby
mode.
