3
PeerCall User’s Manual
During the conversation, if the receiver hangs up the phone or press <Exit>, the
message
End of Talk
will be displayed for two seconds, then the PeerCall will
be put back to
Standby
mode. But if the link was disconnected due to transmission
difficulties (for more than eight seconds), the display will show
Disconnected
.
At the end of the conversation, just hang up the Handset or press <Exit>.
If receiver didn’t pick up the phone after 30 seconds, it will go to
Record a Voice
Message
mode.
2.2.5
You will hear the
Busy Tone
if the receiver is Busy or Off-Line. In five seconds,
PeerCall will go to
Record a Voice Message
mode. The display will show either
Busy...
or
Off-line...
.
2.2.6
You will hear the
Busy Tone
for dialing a non-existing (or an un-subscribed) number,
the message
Invalid #
will be displayed with a
warning (buzzer) sound
. You
should check the number you have dialed before trying to dial again later.
Want to make a quick test? Just dial 222-222-2222. You should hear the voice:
Thank you for using PeerCall. If you hear this message, your PeerCall is
working properly. Enjoy using it!
2.3 Access a Previous Number from Call list
2.3.1
From
Standby
or
Dial up
mode, press <Previous> or <Next> button directly to
browse the Call List.
2.3.2
If the Call List is empty, the message
No Call List
will be displayed with a
warning (buzzer) sound
. The user can hang up or press <Exit> button to put the
PeerCall back to
Standby
mode.
2.3.3
Up to 20 most recent outgoing (
) and incoming (
) calls will be recorded in the
Call List. When CALL RECORD is on, Call ID numbers, sequence number and the
time of call will be displayed. For calls that were not connected (such as line busy,
off-line etc.), the failed (
) icon will be on.
2.3.4
Press <OK> to start the calling. Go to
2.2.4
for the rest of the calling procedure.
2.4 Access the Phone Book
2.4.1 Save a phone number to the Phone Book
At
Dial up
mode, dial the ten-digit PeerCall number, then press <Function>. The
