2
PeerCall User’s Manual
You can apply to extend the service before the expiration date.
2. Make a Call
2.1 Standby
PeerCall will display
Starting...
during the power-on process. There will be a sound
of Chime once the PeerCall is on and connected successfully. It will then show the phone
number for two seconds before entering Standby mode if it is ready for
Dialup
. The
message
PeerCall 100
and the current time will be displayed. The number, i.e. 100, is
the model number of the product. One of the TheDHCP, PPPoE, or FxIP will be on to
indicate the current network connection mode, if it indicate DHCP Failed, it means your
connection may be PPPoE or FxIP type, please check with your MIS manager or ISP to
confirm your connection type, and refer to
5. Phone Set-Up
to change network mode.
When user is using the PeerCall, pressing <Exit> button or hanging up the Handset will
put the phone back in Standby mode. The PeerCall will be put back to Standby mode
also if user didn’t press any key for more than 30 seconds, except during talking,
recording a greeting, or recording voice messages.
Please note, the first time the user plugs in the PeerCall, the server will assign a phone
number for it. The User can always display
the current PeerCall phone number
by
using
Show System Information
function.
The PeerCall would not be able to function properly if it could not connect to a server.
The message
Not Ready...
will be displayed. PeerCall will automatically try to
reconnect to the server until a connection is established. If the service subscription
has expired, the message
Service End
will show on the screen. For a complete list
of Power-on Messages, please refer to
Appendix A
. The PeerCall is able to receive
text messages from the server in Standby mode.
2.2 Dial a Number
2.2.1
The user can either pick up the Handset or press any digit to go to Dialup mode
(section 2.2.2). For the PeerCall model with a hook, the display will be replaced by
Please Dial
with the
dial tone
.
2.2.2
Dial the ten digit PeerCall number. There is a
tone
for each key when pressed. To
erase the last digit, press <Clear>. Press <Exit> or hang up the Handset to put
PeerCall back to
Standby
mode.
Please note, the user can switch to
Access a Previous Number
mode by pressing
<Previous> or <Next> button
ONLY
when all digits are erased. The user can
switch to
Save Phone Book
mode by pressing <Function> button.
2.2.3
Press <OK> to start calling.
2.2.4
You will see a
Calling...
message (and hear
Ring Echo Tone
) before the
receiver picks up the phone (please also refer to
Answer a Call
).
If the receiver picks up the phone, you can start talking. The display will show
Talking...
, the outgoing (
) icons will be on, the current time, hh:mm mo/dy
and the elapsed time ee (in minutes) will be displayed.
