orolia.com
EdgeSync Manual rev 1 | 9
•
User Interface and Control Plane Processor, which supports all the user access and connectivity
to the entire system. The Processor supports DHCP, HTTP webpage/CLI access, SSH, SFTP,
XML and SNMP (v2, v3).
•
GNSS Receiver – GPS Receiver combined with either a Beidou or Glonass or Galileo Receiver
with external antenna input. The selection of the constellation is user configurable.
2.
Installation
Before the EdgeSync is installed, review the information in this section. If difficulties are encountered
during the installation process, contact Orolia Customer Support, with the contact information
provided in the Contact Section of this User Guide.
Security Recommendations
The EdgeSync Management port and PTP Timing ports should be installed behind the company’s
firewall to prevent public access. Additionally, the PTP Timing ports should be connected to a Local
Area Network (LAN) or Wide Area Network (WAN) dedicated to transporting PTP timing messages.
Environmental Requirements
The EdgeSync operating temperature is 0°C to 50° C (-32°F to 122° F). Use only shielded cable for all
signal wiring, including I/O, clocks and Ethernet. Use the Ground connector to appropriately ground the
EdgeSync to earth ground.
Packaging List and Unpacking
The EdgeSync box contains the following:
•
The EdgeSync Multi-Sync Gateway
•
AC/DC power supply and spare terminal block connector
GNSS antenna and accessories, rack mounting bracket and secondary AC/DC power supplies are
available.
The EdgeSync is packaged to be protected from normal shock, vibration, and handling damage during
shipment. Unpack and inspect the box contents as follows:
1.
Wear a properly grounded protective wrist strap or suitable ESD protection.
2.
Inspect the shipping box for signs of damage. If the box appears to be damaged, notify both the
carrier, and Orolia or your Orolia distributor. Retain the shipping box and packaging material for
the carrier to inspect.
3.
Open the box, being careful to cut only the packaging tape.
4.
Locate and save the printed packaging list and paperwork that is included in the box.
5.
Remove the EdgeSync from the box and place the unit on an anti-static surface.
6.
Locate and set aside additional parts which may be contained in the box.
