Orion TC1973D, Руководство по обслуживанию

Страница: 5 / 36

ELECTRICAL ADJUSTMENTS
10
AGC
4. Activate the adjustment mode display (Fig. and
press the 2 key.
5. Adjust VOL. UP/DOWN key on the remote
control until
the waveform maker becomes as shown in
Fig. 2-4-b.
6.
7.
6.
9.
45.75 MHz
Fig. 2-4-t
Disconnect output terminal the sweepmarker generator
from
then connect it to TP al the tuner pack.
Disconnect the ohm and the ohm variable
resistors.
Disconnect input and output terminals of the
sweepmarker generator.
Connect the AFT adjustment oscillator
to TP of the tuner pack.
1 the digital voltmeter to TP206.
1 the adjustment display (Fig. 2-3) and press
the 3 key.
VOL. UP/DOWN key on the remote control to find
the point where the voltage of changes dramatically,
and adjust to at that point.
2-2: BRIGHT, AGC, TINT AND COLOR
2-2-A: BRIGHT
Receive the monochrome pattern.
2. Activate the mode and
press the 7
3. Press the VOL. UP/DOWN key on the remote control
until the boundary between 0% and 10% white starts
to become visible.
2-2-B: AGC
NOTE
Adjust after performing adjustments in section 2-1.
In case of weak electric field.
1. Tune to a noisy channel.
2. Activate the adjustment mode display and press
the 4 key.
3. Press the VOL. UP/DOWN key on the remote control
until noise is at minimum.
4. Change the channel. confirm that the other channels
are normal.
In case of strong electric field.
(Radio frequency interference diagonal
streaks to appear.)
1. Activate the adjustment display and press 4
2. Press the VOL. UP/DOWN key the remote
diagonal streaks are at minimum.
3. If there is still a problem after pressing the VOL. UP/DOWN
key on the remote control. install an attenuator to the
terminals. then repeat step
4. Confirm that noise does not appear.
5. Change the channel. confirm that the other channels
normal.
2-2-C: TINT
Receive the color bar pattern.
2. Connect the oscilloscope to TP023.
3. Activate the adjustment
display (Fig. 2-3) and press
the 6 key.
4. Press the VOL. UP/DOWN key on the remote control
the waveform becomes as shown in Fig.
1
Fig.
2-2-D: COLOR
Receive the color bar pattern.
2. Connect the oscilloscope to TP022
3. Activate the adjustment mode (Fig. 2-3) display and press
the 5 key.
4. Adjust the VOLTS RANGE VARIABLE knob of the
oscilloscope until the range between white 0% and CO%
is set to 5 scales on the screen of the oscilloscope.
5. Press the VOL. UP/DOWN key an the remote control
the red color level is adjusted to for
white level. (Refer to Fig. 2-6)
1 0 0 %
7