Maintenance
29
7-4
Adjusting the belt tension and replacing the belt
Adjust the belt tension of the parallel motor mounting type, or replace the belt.
•
When adjusting the belt tension or replacing the belt, remove the load, and
perform in a state where the motorized linear slide is placed in a horizontal position.
Doing the operation in a vertical condition may allow the moving part to fall,
leading to injury or mechanical damage.
•
Set the home again after mounting a motor. If the motorized linear slide is operated
without setting the home, the moving part may move to unexpected directions or
run at unexpected speeds, leading to injury or mechanical damage.
• The moving part of the motorized linear slide may collide with the mechanical
stopper.
• The load may collide with other equipment.
Belt for maintenance
For the belt for maintenance, contact your nearest
Oriental Motor sales office.
Model
Belt model
EZSM3
,
EZSM4
LS-LVCS2M060186
EZSM6
LS-LVCS3M080252
Working procedure
This section explains about the
EZSM4
type as an example. With the
EZSM6
type, the motor mounting screws are
located in the rear side of the motor.
Motor mounting screws
Motor mounting screws
EZSM3
,
EZSM4
EZSM6
1. Remove the pulley cover fixing screws, and detach
the pulley cover.
Pulley cover fixing screws (M3)
Pulley cover
2. Loosen the motor mounting screws.
Model
Nominal size
EZSM3
,
EZSM4
M3
EZSM6
M4
Three turns or less
To prevent the motor mounting screw from falling off, keep three turns or less when turning the
screw.
