9
09.07/WE
ORGAPACK OR-V 41 P
CAUTION!
Used where there is dan-
ger to life and health.
WARNING!
Used for danger which
can cause material
damage.
NOTE!
Used for general infor-
mation and information
which if not followed can
cause faults in the
operating sequence.
2
GENERAL INFORMATION
These operating instructions are intended to simplify
familiarisation with the strapping tool and the pos-
sibilities of application for the intended purpose. The
operating instructions contain important information
concerning the safe, proper and effi cient use of the
strapping tool. Observation of the information will help
to avoid danger, reduce repairs and stoppages and
increase the reliability and service life of the strapping
tool.
The operating instructions must always be available
at the place of operation of the strapping tool. They
must be read and observed by all persons concerned
with work on the strapping tool. This work specifi cally
includes operation, refi lling of operating material, fault
elimination and maintenance.
In addition to the operating instructions and the regu-
lations for accident prevention effective in the country
of use and place of application, the recognised tech-
nical regulations for safety and proper working must
also be observed.
2.1
INFORMATION
ON
ENVIRONMENTAL
PROTECTION
This tool is manufactured without any physical or che-
mical substances which could be dangerous to health.
For disposal of all the parts, the governmental instruc-
tions must be observed.
2.2 COMPRESSED-AIR CONNECTION
The sealing piston is lubricated by oil mist of the
compressed air. Properly prepared compressed air
is therefore essential for trouble-free operation of the
tool. This can only be ensured by a reliably functio-
ning maintenance unit, consisting of water separator,
pressure reducing valve with pressure gauge and oil
mist lubricator.
The oil mist lubricator should supply suffi cient oil. The
length of the hose between the OR-V 41 P and the
maintenance unit should not exceed 5 m (15 ft). The
internal diameter of the pipe should be at least
10 mm (
3
/
8
“). It must be ensured that the hose does
not form loops, where oil can collect.
