Oreck UK2200, Руководство пользователя

Страница: 7 / 22

13 12
WARNING
TO REDUCE THE RISK OF ELECTRIC SHOCK AND INJURY FROM MOVING PARTS - UNPLUG BEFORE
CLEANING OR SERVICING.
CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK AND INJURY FROM MOVING PARTS - UNPLUG
BEFORE SERVICING.
Maintenance: Checking & Replacing
Brushroll Belt
Maintenance: Clearing Blockages
1
Remove the service
door by removing
the hold down screw
located on side of
power head.
1
An overloaded
filtration bag may
cause dirt and debris
to back up into the air
flow system. Open the
bag dock and check
for visible clogs at the
bag port.
Change filtration bag
if contents have
reached the
MAXIMUM FILL LINE.
4
Loop the new belt over
the motor shaft. Place
the opposite end of the
belt on the brushroll
pulley.
2
Slide the door forward
by prying open with a
screwdriver or coin.
2
Also, check for
blockages in the
power head nozzle.
If you can’t reach the
blockage, remove
the baseplate.
5
Rotate the brush roll
three (3) complete
revolutions to ensure
that no part of the belt
is overhanging the end
of the motor shaft.
4
Twist lower
tube connector
counterclockwise
and slide up. Pull the
lower tube (A) out of
the fan housing. Once
removed, check for
blockage.
3
Remove the brushroll
belt from the motor
shaft and brushroll
pulley.
3
If blockage is not in
the power head nozzle,
remove the lower tube.
Unhook the case clasp
releasing the filtration
bag case.
6
Replace the door
by sliding it into the
groove at the bottom
of the housing. Replace
the hold down screw.
5
If the lower tube is
not blocked, look into
the fan housing (B) for
blockage. Be sure to
reassemble lower tube
and tighten the lower
tube connector before
continuing use.
LUBRICATION
The motor and brushroll are equipped with bearings which contain sufficient lubrication for their
lifetime. The addition of lubricant could cause damage. Do not add lubricant to motor or brushroll.
LUBRICATION
The motor and brushroll are equipped with bearings which contain sufficient lubrication for their
lifetime. The addition of lubricant could cause damage. Do not add lubricant to motor or brushroll.